DIN 931-1 H1150 Hex Bolt – ASTM A564 Type 630 Stainless Steel

The DIN 931-1 H1150 hex bolt combines a wrench-driven hex head, an unthreaded shank and a threaded end. It is made from Type 630 precipitation-hardening stainless steel, also known as 17-4PH or UNS S17400, in the H1150 condition. The M8 × 45 configuration shown below has an M8 × 1.25 thread and a 22 mm nominal threaded length.

Product Features

  • Type 630 stainless steel: A precipitation-hardening alloy for applications that need a combination of mechanical strength and corrosion resistance.
  • H1150 heat treatment: An aging condition selected when ductility and toughness are priorities alongside strength. H1150 identifies the heat-treatment condition, not a service-temperature rating.
  • Partially threaded shank: The unthreaded section can span part of the joint grip, while the threaded end engages a mating nut or tapped hole. Check grip length and thread engagement against the assembly drawing.
  • External hex head: Allows installation with a wrench or socket where the assembly provides sufficient tool clearance.

DIN 931-1 H1150 Hex Bolt Specifications

The table shows the M8 × 45 configuration. Confirm the dimensions, tolerances and acceptance criteria for the size being ordered.

ParameterM8 × 45 Configuration
Product formPartially threaded hex head bolt
Dimensional referenceDIN 931-1:1987-09
Material specificationASTM A564/A564M Type 630 stainless steel
Alloy designation17-4PH / UNS S17400
Heat-treatment conditionH1150
ThreadM8 × 1.25, right-hand metric coarse
External thread tolerance6g
Nominal length under head45 mm
Nominal threaded length22 mm
Nominal width across flats13 mm
Surface finishCleaned stainless steel surface

Material, Dimensions and Inspection

ASTM A564/A564M specifies the stainless steel bar or shape used as starting material. Specify the finished bolt dimensions, final heat-treatment condition and mechanical acceptance criteria separately. A material certificate for the starting stock does not establish the tensile strength or hardness of the finished bolt lot.

DIN 931-1:1987-09 is a withdrawn dimensional reference that may still appear on legacy drawings. If the drawing calls for DIN 931-1 and the proposed replacement follows ISO 4014, check the head dimensions, thread length and shank fit before approving the substitution.

For orders with inspection requirements, identify the critical dimensions, thread checks and any finished-lot hardness or tensile testing required. If the drawing calls for passivation, specify it separately from the cleaned surface finish. See Flybear’s quality control overview when preparing the inspection scope.

Typical Applications

Consider this Type 630 H1150 hex head bolt for machinery assemblies, equipment brackets and mounting connections on pump, valve or power equipment where the drawing specifies 17-4PH stainless steel and a partial thread. For marine or chemical exposure, confirm suitability against the actual environment. Pressure-retaining joints require the bolting specification and acceptance criteria defined by the equipment design.

If the joint needs threads close to the head or a different grip length, review the available hex bolt configurations before ordering.

Request a Quotation

Flybear supports sourcing for standard and drawing-based hex bolts. To request a quotation, send the bolt diameter, pitch, length, required threaded length, quantity and drawing revision. Include the Type 630 and H1150 requirements, surface finish, and any material certificates or finished-lot test reports needed for acceptance.

facebook (2)instagram 2 youtube (1)linkedin (1)

Scroll to Top